What the official UPS identities actually say
The Unified Pension Scheme sits under the National Pension System and is administered with PFRDA regulations notified on 19 March 2025. PFRDA’s public FAQ and the NPS Trust UPS calculator use the same two payout identities this page implements. The assured payout is A = (1/2 P) times (Q/300), where P is the average basic pay drawn in the 12 months immediately before superannuation, and Q is qualifying service in months. Q below 120 months means the assured payout is not available. Q above 300 months is capped at 300, so a 30-year career and a 35-year career produce the same 50%-of-P ceiling. If the formula produces less than Rs 10,000 after that 10-year gate, the admissible payout is Rs 10,000 a month.
A worked default on this page uses P = Rs 80,000 and 25 years (Q = 300). Half of P is Rs 40,000; times 300/300 that is Rs 40,000 a month. The same P with only 15 years (Q = 180) produces Rs 24,000. A low-pay example, P = Rs 15,000 and Q = 120, produces a raw figure of Rs 3,000, which the floor lifts to Rs 10,000. Those three identities are what the test suite checks against PFRDA’s published formula, not against a screenshot of any particular employee’s PPO.
A separate lumpsum is allowed in addition to the monthly payout: (E/10) times L. E is last basic pay plus non-practising allowance, if any, plus dearness allowance on that sum at the rate applicable on superannuation. L is the number of completed six-month blocks in the qualifying service. For the default 25-year career, L is 50. With last basic Rs 80,000 and DA at the 63% Central rate notified from 1 July 2026, E is Rs 1,30,400 and the lumpsum is Rs 6,52,000. Family payout is described as 60% of the admissible payout the subscriber was drawing immediately before death; the page shows 60% of the assured amount and then the same figure with the DA/DR rate you typed. Confirm with the latest PFRDA / NPS Trust note whether a particular dearness increment rides on the family amount in your case.
How the NPS column is built — and what it is not
NPS does not promise a percentage of last pay. The corpus is the sum of employee and employer contributions, invested in the funds you chose, minus charges. This page models contributions as an annuity-due SIP (a deposit at the start of each month) for Q months at the annual return you type, default 10%. That is a planning identity used across Indian SIP calculators; it is not the NPS Trust’s official corpus estimator and it ignores actual Tier-I allocation, resets and partial withdrawals. Out of that modelled corpus, the default 40% is treated as the amount used to buy an annuity, which matches the familiar minimum annuity-purchase share many subscribers discuss at exit. The remaining 60% is shown as a lumpsum. The monthly annuity is then corpus_annuity times (annuity rate / 100) / 12, using a flat rate you type (default 6%). Real annuity quotes depend on the insurer, the annuitant’s age, the frequency and whether the spouse is covered. Treat the NPS monthly figure as an illustration sitting next to UPS’s fixed formula, not as a premium quotation.
The default contributions — Rs 10,000 from you and Rs 5,000 from the employer — are only an example so the two columns have numbers on the same screen. Central UPS / NPS contribution rates and options are set by government orders and PFRDA regulations; type the rupee amounts that actually leave your salary slip. Returns can be higher or lower than 10%. A weaker return shrinks the NPS corpus and the modelled annuity; it does not change the UPS assured payout, which is why people compare the two in the first place.
Reading the comparison without turning it into advice
UPS answers “what monthly amount does the formula give me from my last pay?” NPS answers “what might a contribution stream grow into, and what monthly income might an annuity then buy?” Those are different risks. UPS still depends on qualifying service being correctly counted and on the government honouring the notified formula and dearness adjustments. NPS depends on markets and on the annuity market at the moment you retire. This website does not tell you which scheme to pick, whether an existing NPS subscriber should exercise a UPS option, or how a switch would treat past corpus. Those choices have windows, forms and employer certifications that only your PAO, DDO or the NPS Trust can complete.
Dearness relief on UPS payouts is entered by you (default 63%, the Central DA/DR rate from 1 July 2026 under the Department of Expenditure order of 29 October 2026). Future DR revisions will change the “with DR” line without changing the underlying (1/2 P) times (Q/300) identity. If you want a figure before DR, read the assured-payout line. If you want a figure that resembles a pension slip with the current Central rate, read the with-DR line. Neither line is a PPO.
Qualifying service shorter than ten years is shown as “not applicable” for the assured payout rather than inventing a proportion or a refund rule. PFRDA’s FAQ is explicit about that ten-year gate. Superannuation benefits in that case follow the separate exit provisions; open the FAQ and the NPS Trust UPS calculator for the official wording rather than assuming a linear 10-year interpolation. Service longer than 25 years does not raise the 50% ceiling, but it does increase L and therefore the lumpsum, because L counts six-month blocks without the 300-month cap that applies to Q in the monthly formula.
Official sources
- PFRDA — Frequently asked questions on the Unified Pension Scheme (formulae for assured payout, floor, lumpsum and family payout)
- NPS Trust — official UPS calculator
- PFRDA (Operationalisation of Unified Pension Scheme under the National Pension System) Regulations, 2025, notified 19 March 2025
- Department of Expenditure — DA/DR 63% from 1 July 2026 (OM 1/2(i)/2026-E.II(B), 29 October 2026), used only as the default DR rate you can edit